Chapter 10 Online
10-50
10.15 Fault Mask
It is used to decide to keep running the module in Fault or not during PLC operation.
[Steps]
1. Select [Online]-[Fault Mask Setting].
[Dialog Box]
[Description of Dialog Box]
a. Base Fault Mask: used to decide to apply base module’s fault mask or not. If the base module’s mask is
specified, all slots in the base will be of the fault mask.
b. Slot Fault Mask: used to decide to apply the fault mask for each slot or not.
c. Show Existing Base Only: shows existing base only
d. Details: displays detailed information of the special module or the communication module only.
e. OK: applies the changed items and closes the dialog box.
f. Cancel: closes the dialog box.
a
d
f
b
e
c
To Next Page
Loading...
