LS Industrial Systems XG5000 - Adjust No. of Contact Point

Chapter 5 LD Edit
5-40
5.3.8 Adjust No. of Contact Point
It is used to adjust the number of contact points displayed in the screen. Here, the number of contact points
is total number (horizontal cell - 1), excluding the output position.
[Steps]
1. Select [View]-[Change Columns]-[Increase Columns] on the menu.
If the data in the very right of the present screen is larger than the number of contact points to display, it may
be displayed by rung including arrow.
Notes
- If View Options are changed, it may take some time according to the edited program amount.
- Print function of the Device/Variable/Comment is available. For more detail, refer to CH14.