Chapter 10 Online
10-32
10.12 Flash Memory Setting
Flash memory operation of PLC can be specified.
Flash memory operation: When PLC operation mode Changes to Run, it executes Run operation after
copying the program in the flash memory to the program memory. In other words, it runs PLC through the
program in the flash memory.
(PLC operation in Run mode: it means that the operation mode changes from Stop to Run, and that the
operation mode is Run when PLC is powered back on)
[Steps]
1. Select [Online]-[Connect] to connect to PLC.
2. Select [Online]-[Set Flash Memory].
[Dialog Box]
[Description of Dialog Box]
a. Enable flash memory run mode: specifies the flash memory’s operation mode.
b. Disable flash memory run mode: cancels the flash memory’s operation mode.
a
b
To Next Page
Loading...
