Chapter 10 Online
10-18
10.7 Reset PLC
It is used to reset PLC. Reset PLC is also available with ‘Reset PLC’ dip switch.
[Steps]
1. Select [Online]-[Connect] to connect to PLC.
2. Select [Online]-[Reset PLC].
3. After reset type selected, click [OK] button to reset PLC.
[Dialog Box]
Notes
- Reset and Overall reset are available for its type.
- Reset: when PLC powered back, it will delete error/warning information to allow power on. Error/warning
may occur continuously based on the situation.
- Overall reset: when PLC powered back, it will delete error/warning information, latch 1 area data, I/O skip,
error mask and forced I/O setting area to allow power on..
- Be careful! PLC after reset will be off and then on again.
To Next Page
Loading...
