Chapter 11 Monitoring
11-28
a. Select items on the module information window. (Ex. Base 0, Base 1, …)
b. Select [Base] items on the menu. (Select First, Previous, Next, Last base)
c. Use the direction key on the keyboard to position the module’s cursor on the base to select.
Notes
a. If System Monitoring is executed on the XG5000 menu, it will be in Connect and Monitoring status.
11.4.2 Connect/Disconnect
System Monitoring can be created by a call from XG5000, or can be also executed solely.
Thus, the connection is available to PLC with Connect options. If connected with PLC, base information is
read from PLC to display on the module information window.
[Steps]
1. Specify Connect options.
2. Confirm that cable is installed applicably to connection method.
3. Select [PLC]-[Connect] on the menu to connect.
4. Select [PLC]-[Disconnect] on the menu to disconnect.
Notes
a. System Monitoring when executed will start to connect with the saved Connect options.
b. If executed in XG5000, it will start to connect with XG5000’s Connect options.
c. Default of Base 0 will be displayed on the screen.
11.4.3 System Synchronization
It reads base information, I/O assignment method and slot information specified in PLC to display on the
screen. When monitored, it will read I/O skip information and forced I/O input/output information to change
the current value.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[System Synchronization] on the menu.
To Next Page
Loading...
