Chapter 8 Find/Replace
8-22
a
b
c
d
e
f g
h
i
j
k
8.4 Replace String
This function is used to find the String of Comment, Variable, etc. except the device.
[Dialog Box]
[Description of Dialog Box]
a.Replace With: used to specify the string to find.
b. Find What: used to specify the string to replace.
c. Match whole word only: If All Identical checked, it will find the string only exactly identical to the string
specified in the detail to find. If not checked, it will find also the string where the detail to find is included.
d. Case-sensitive: If this checked, it will find the string only exactly identical to the string with Case-sensitive
characters sorted out. If not checked, it will find the string in characters not sorted out.
e. Include variable: If this checked, the variable will be also replaced as applicable when the string is
replaced. If this is not checked, the variable will not be included in the replace when the string is replaced.
f. Direction: used to specify the location to find upward or downward from the line presently selected in the
respective editor...
g. Range: if selecting a range, Replace String can be executed within a specific line. If Range is selected,
the first and last steps should be entered.
h. Find Next: finds the detail specified above right in the next to the line (position) presently selected. If the
applicable string is found, the cell will move to the position the applicable string is located.
i. Replace: replaces the detail specified above after found.
j. Replace All: replaces all the details specified above after found.
k. Advanced>>: It is only used in Ladder editor. ‘Advanced>>’ and ‘Advanced<<’ is changed by click. It is
used to find specific contact point, specific coil, extended function, function/function block used in Ladder
editor.
To Next Page
Loading...
