LS Industrial Systems XG5000 - Trace

Chapter 11 Monitoring
11-98
11.8.4 Trace
It is used to read the data traced from PLC or the data specified.
1) Write Trace Setting
It applies the trace setting to PLC.
[Steps]
1. Select [Trace]-[Write Trace Settings] on the menu.
2) Read Trace Settings
It is used to read trace setting from PLC.
[Steps]
1. Select [Trace]-[Read Trace Settings] on the menu.
3) Read Data Traces
It reads trace data from PLC.
[Steps]
1. Select [Trace]-[Read Trace] on the menu.
4) Start Manual Trace
It is used to start to trace data under the trace condition presently specified.
[Steps]
1. Select [Trace]-[Start Manual Trace] on the menu. If data is presently traced, the applicable menu will be
inactive.