LS Industrial Systems XG5000 - 2.2 Open;Close Project

Chapter 2 Basic Application
2-16
2.2 Open/Close Project
2.2.1 Open Project
[Steps]
1. Select [Project]-[Open Project] on the menu
2. Select [Project File] and then click [Open]
Note
- The extension of XG5000 project file is “.xgp”. On the Open Dialog Box, select Project File to check the
project comment in the comment area
2.2.2 Close Project
[Steps]
1. Select [Project]-[Close Project] on the menu. Default of the Shortcut Key is not specified
2. If the project is not saved after edited, the following message will appear.
3. Click [Yes] to save.
2.2.3 Save Project
[Steps]
1. Select [Project]-[Save Project] on the menu.
Note
- The mark “*” displayed to the right of the project name on the project window means that the present
project has been edited