Chapter 11 Monitoring
11-66
11.5.12 Start/Stop Monitoring
It reads the device data from PLC to display on the screen in the on-line status, or it stops reading the data.
1) Start Monitoring
It reads the device data from PLC to display on the screen in the on-line status.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[Start Monitoring] on the menu.
2) Stop Monitoring
It stops reading the device data from PLC in the on-line status.
[Steps]
1. Confirm the connection status with PLC.
2. Select [PLC]-[Stop Monitoring] on the menu.
Notes
a. If in monitoring mode, the data can not be edited.
b. If in monitoring mode, [Write to PLC], [Read from PLC], [Write Selected Area to PLC] are not available.
11.5.13 Change Current Value
It is used to change the data value of the cell in monitoring mode.
[Steps]
1. Ensure PLC is connected and the monitoring mode is active.
2. Select [PLC]-[Change Current Value] on the menu.
3. Dialog box of Change Current Value will be called.
To Next Page
Loading...
