Chapter 11 Monitoring
11-8
3. Positive-converted detection contact point: displayed as identically as ordinarily open contact point.
4. Negative-converted detection contact point: displayed as identically as ordinarily closed contact point.
[Coil Monitor Display]
a. Coil: If applicable coil’s value is On status, device (or variable) value will be displayed in red, and the
power flow inside the coil in blue.
b. Reverse-coil: If applicable coil’s value is On status, device (or variable) value will be displayed in red, and
the power flow inside the coil will not be displayed.
c. Set coil: displayed as identically as coil.
d. Reset coil: displayed as identically as (negative) coil.
e. Positive-converted detection coil: displayed as identically as coil.
f. Negative-converted detection coil: displayed as identically as coil.
[Monitor Display of Function(Block)]
Monitoring value is displayed on the IO parameter of function(block). The data of function(block) IO parameter
is displayed based on monitoring display format.
To Next Page
Loading...
