Chapter 6 SFC Edit
6-49
4) Go To END Command
[Steps]
1. Select [Find/Replace]-[Go To]-[END Command] on the menu.
[Dialog box]
[Dialog box description]
a. Program: displays current PLC program list. If you select ‘All program’, it displays list of all END command.
b. Label list: displays list of END command used in the selected program.
c. Go to: closes dialog box and goes to selected END comment.
d. Close: closes dialog box without save.
2. Select the END command you want to go.
Notes
- Go To END command is available in the LD program.
- It doesn’t operate about LD used in the SFC program’s Action/Transition.
a
b
d c
To Next Page
Loading...
