Chapter 9 Parameter
9-2
b. Fixed period operation: used to decide to run the PLC program based on the fixed period operation or
based on the scan time.
c. Fixed period operation time setting: if Fixed period operation above is checked, input the operation time in
ms unit.
d.Watch Dog timer: used to specify the time value of the scan watch-dog timer to keep PLC from stopping
due to program error.
e. Standard input filter: used to specify the standard input value. For more details, refer to the 9.2.4 notes.
f. Restart mode: sets the restart mode. Select either cold or warm restart.
g. Output during debugging: used to decide to output the data to the output module as usual or not even
while being debugged.
h. Keep Output when an error occurs: used to decide to output the data to the module as usual or not even
when an error or a specific input occurs.
i. Keep Output when converting RUN->STOP: used to decide to output the data to the module as usual or
not even when PLC operation mode is converted from RUN to STOP.
j. Keep Output when STOP->RUN: used to decide to output the data to the module as usual or not even
when PLC operation mode is converted from STOP to RUN..
k.Exclusive function for event input module: refer to CH 19 event input module
l. Disable Reset switch: determines whether to disable the Reset switch of CPU module.
In case of disabling Overall Reset, only Overall Reset is disabled.
m. Disable Reset switch: determines whether to disable the D.CLR switch of CPU module.
In case of disabling Overall D.CLR, only Overall D.CLR is disabled.
To Next Page
Loading...
