Chapter 10 Online
10-3
[Dialog Box]
Notes
- Default is RS-232C COM1 with the communication speed of 115200bps.
- 38400bps and 115200bps available for communication speed.
- Communication speed is 115200bps for XGT Series, and 38400bps for remote connection via Rnet.
- Communication ports of COM1 ~ COM8 are available.
- If USB serial device is used, a virtual COM port will be applied to the communication port. Check
the device administrator to ensure the specified port number.
- Connection in XG5000 and Connection in XG-PD, device monitor and system monitor are
available with one PLC at the same time. However, it shall be of identical Connect Options.
2) Connection of Local USB
1. Select the Connection Type of USB.
2. USB has no detailed setting options. Thus the setting button is inactive.
3. Click [OK] to save the Connect Options.
Notes
- USB device driver has to be installed for USB to connect to PLC. If not, let it installed prior to the
connection.
- When XG5000 is installed, USB driver will be installed automatically. If USB driver is not normally
installed, download the applicable driver from LSIS Home Page to install.
To Next Page
Loading...
