Chapter 10 Online
10-6
[Dialog Box]
[Description of Dialog Box]
a. Network type: used to specify PLC communication module type for remote connection. Rnet, Cnet, FEnet
and FDEnet are available for the communication modules
b. Base number: used to specify communication module’s base number of local PLC base.
c. Slot number: used to specify communication module’s slot number of local PLC base.
d. Station number: used to input communication module’s specified station Number of Remote 1.
e. IP address: used to input communication module’s specified IP address of Remote 1.
f. Cnet channel: Select the connection channel port if the communication module of Remote.1 connection is
Cnet module
Notes
- Only if the network type is FEnet, IP address will be active. If not, IP address will be inactive with the Station
number active
- Base number of 0~7 and slot number of 0~11 is available.
a
b
c
d
e
f
To Next Page
Loading...
