Chapter 11 Monitoring
11-75
[Description of Dialog Box]
a. FLAG Monitor (applicable only to HS counter module): Flag monitoring function is used to execute
instructions for HS counter module. The user can check the instruction and input signal status along with
HS counter monitoring/test screen as well as Flag monitoring screen (refer to Fig. 2) displayed at the same
time.
b. Parameter Setting Screen: Parameter setting screen is divided into parameter changing area (setting
value) and confirming area (current value) that the changed parameter is successfully transferred to the
module during monitoring.
c. Start Monitoring: Click [Start Monitoring] button to start monitoring being displayed on the screen. Click the
button once more to stop monitoring.
d. Test: After changing the parameter at the bottom of the Monitoring/Test screen, click [Test Start] button to
start to test the operation of applicable special module, which will directly transfer the parameter
information to the module so to display its result on the monitoring screen for the user to confirm.
e. Contact Point Input Signal Status Screen: The user can confirm HS counter status of input contact point
signal (ON/OFF) through the upper of the Flag monitoring screen.
f. Instruction Screen: The user can execute the instruction for HS counter operation and additional functions
at the bottom of the Flag monitoring screen. If the instruction is correctly executed, the status of the
applicable instruction will be displayed in ON/OFF on the button.
Notes
a. HS counter Flag monitoring and instruction functions are available with HS counter module selected by
the user on the special module screen.
To Next Page
Loading...
