Chapter 16 XG-SIM
16-3
3. By selecting [Online] – [Change Mode] – [Run] in XG5000 Menu, execute the downloaded program. For available online menus of
XG5000 when XG-SIM is executed, refer to the following table.
Menu Support Menu Support
Open from PLC ○ Fault mask setup
Ⅹ
Convert mode (run) ○ Module change wizard
Ⅹ
Convert mode (stop) ○ Start modification during run ○
Convert mode (debug) ○ Write modification during run ○
Disconnect
Ⅹ
End modification during run ○
Read
Ⅹ
Start/end monitor ○
Write ○ Pause monitor ○
Compare to PLC
Ⅹ
Resume monitor ○
Flash memory setup (set)
Ⅹ
Monitor pause setup ○
Flash memory setup (cancel)
Ⅹ
Change current value ○
PLC Reset
Ⅹ
System monitor ○
PLC Removal ○ Device monitor ○
PLC info (CPU) ○ Special module monitor ○
PLC info (Performance) ○ User event ○
PLC info (password) ○ Data trace ○
PLC info (PLC clock) ○ Start/end debug ○
PLC history (error log) ○ Debug (run) ○
PLC history (mode conversion
log)
○ Debug (step over) ○
PLC history (power off log) ○ Debug (step in) ○
PLC history (system log) ○ Debug (step out) ○
PLC error warning ○ Debug (move to cursor) ○
I/O info ○ Set/cancel break point ○
Forced I/O setup ○ Break point list ○
I/O skip setup ○ Break condition ○
To Next Page
Loading...
