Learning to Perform Basic Operations
How to use the status bar
On the top-right corner of the display, there is a display item. This item is displayed as long
as the inverter is on, regardless of the mode the inverter is operating in.
• In the top-right corner of the display, the frequency
reference is displayed (factory default).
• Enter Config mode and go to CNF-20 to select the
item to display.
• Press the [PROG/ENT] key to change the item to
‘Output Current.’
• On the top-right corner of the display, the unit changes
from ‘Frequency’ to ‘Current.’
• In monitor mode, the status bar item is changes to
‘Current.’
To Next Page
Loading...
