Learning to Perform Basic Operations
3.2 Learning to Use the Keypad
The keypad enables movement between groups and codes. It also enables users to select
and configure functions. At code level, you can set parameter values to turn on or off
specific functions, or decide how the functions will be used. Refer to 8 Table of Functions on
page 302 to find the functions you need.
Confirm the correct values (or the correct range of the values), and then follow the
examples below to configure the inverter with the keypad.
Display Mode Selection (30-75kW models only)
The following figure illustrates how the display modes change when you press the [Mode]
button on the keypad. You can continue to press the [Mode] key until you get to the desired
mode.
User mode and Trip mode are not displayed when all the inverter settings are set to the
factory default (User mode must be configured before it is displayed on the keypad, and
Trip mode is displayed only when the inverter is at fault, or has previous trip fault history).
To Next Page
Loading...
