LSIS LSLV-S100 - Fault;Warning List

Learning Protection Features
271
6.4 Fault/Warning List
The following list shows the types of faults and warnings that can occur while using the
S100 inverter. Please refer to 6 Learning Protection Features on page 250 for details about
faults and warnings.
Category
LCD Display
Details
Major fault
Latch type
Over Current1
Over current trip
Over Voltage
Over voltage trip
External Trip
Trip due to an external signal
NTC Open
Temperature sensor fault trip
Over Current2
ARM short current fault trip
Option Trip-x*
Option fault trip*
Over Heat
Over heat fault trip
Out Phase Open
Output open-phase fault trip
In Phase Open
Input open-phase fault trip
Inverter OLT
Inverter overload fault trip
Ground Trip
Ground fault trip
Fan Trip
Fan fault trip
E-Thermal
Motor overheat fault trip
Pre-PID Fail
Pre-PID operation failure
IO Board Trip
IO Board connection fault trip
Ext-Brake
External brake fault trip
No Motor Trip
No motor fault trip
Low Voltage 2
Low voltage fault trip during operation
ParaWrite Trip**
Write parameter fault trip
Level type
Low Voltage
Low voltage fault trip
BX
Emergency stop fault trip
Lost Command
Command loss trip
Safety A(B) Err
Safety A(B) contact trip
Hardware
damage
EEP Err
External memory error
ADC Off Set
Analog input error
Watch Dog-1
CPU Watch Dog fault trip
Watch Dog-2
Minor fault
Over Load
Motor overload fault trip