LSIS LSLV-S100 User Manual

228
Learning Advanced Features
Code
Description
󰪿 Setting range of the user group code. Entering 0 cancels
the settings.
3
Set a code number (󰪽) to use to register the parameter in
the user group. Select code number and press [PROG/ENT]
key.
4
Changing the value in 󰪽 will also change the value in 󰪾. If
no code is registered, ‘Empty Code’ will be displayed.
Entering 0 cancels the settings.
5
The registered parameters are listed in the user group in U&M
mode. You can register one parameter multiple times if
necessary. For example, a parameter can be registered as
code 2, code 11, and more in the user group.
Follow the procedures below to delete parameters in the user group.
No.
Settings
1
Set CNF- 42 to 3(UserGrp SelKey). A icon will be
displayed at the top of the LCD display.
2
In the USR group in U&M mode, move the cursor to the code
that is to be deleted.
3
Press the [MULTI] key.
4
Move to YES on the deletion confirmation screen, and press
the [PROG/ENT] key.
5
Deletion completed.
CNF-25 UserGrp
AllDel
Set to 1(Yes) to delete all registered parameters in the user group.
5.28 Easy Start On
Run Easy Start On to easily setup the basic motor parameters required to operate a motor
in a batch. Set CNF-61(Easy Start On) to 1(Yes) to activate the feature, initialize all
parameters by setting CNF-40 (Parameter Init) to 1 (All Grp), and restart the inverter to
activate Easy Start On. This function is only available on the LCD loader.
Group
Code
Name
LCD Display
Parameter
Setting
Setting
Range
Unit
CNF
61
Parameter easy start
settings
Easy Start
On
1
Yes
-
-

LSIS LSLV-S100 Specifications

General

Brand	LSIS
Model	LSLV-S100
Category	Controller
Language	English