Preparing the Installation
1 Preparing the Installation
This chapter provides details on product identification, part names, correct installation and
cable specifications. To install the inverter correctly and safely, carefully read and follow the
instructions.
1.1 Product Identification
The S100 Inverter is manufactured in a range of product groups based on drive capacity
and power source specifications. Product name and specifications are detailed on the rating
plate. The illustration on the next page shows the location of the rating plate. Check the
rating plate before installing the product and make sure that the product meets your
requirements. For more detailed product specifications, refer to 11.1 Input and Output
Specification on page 397.
Check the product name, open the packaging, and then confirm that the product is free from
defects. Contact your supplier if you have any issues or questions about your product.
To Next Page
Loading...
