LSIS LSLV-S100 User Manual

77
Learning to Perform Basic Operations
Setting Parameter Values
3.2.4.1 0.4-22kW Models
Enable or disable features by setting or modifying parameter values for different codes.
Directly enter setting values, such as frequency references, supply voltages, and motor
speeds. Follow the instructions below to learn to set or modify parameter values.
Step
Instruction
Keypad Display
1
Select the group and code to setup or
modify parameter settings, and then press
the [ENT] key.
The first number on the right side of the
display will flash.
2
Press the [◀] or [▶] key to move the
cursor to the number that you would like to
modify.
3
Press the [▲] or [▼] key to adjust the
value, and then press the [ENT] key to
confirm it.
The selected value will flash on the display.
4
Press the [ENT] key again to save the
change.
-
Note
• A flashing number on the display indicates that the keypad is waiting for an input from the
user. Changes will be saved when the [ENT] key is pressed while the number is flashing.
The setting change will be canceled if you press any other key.
• Each code’s parameter values have default features and ranges specified. Refer to 8 Table
of Functions on page 302 for information about the features and ranges before setting or
modifying parameter values.
5.)

LSIS LSLV-S100 Specifications

General

Brand	LSIS
Model	LSLV-S100
Category	Controller
Language	English