Learning Advanced Features
inverter when a trip condition is released, after the inverter
stops operating due to activation of protective devices (fault
trips).
Used to switch equipment operation by connecting two motors
to one inverter. Configure and operate the second motor using
the terminal input defined for the second motor operation.
Commercial power
source switch
operation
Used to switch the power source to the motor from the inverter
output to a commercial power source, or vice versa.
Used to control the cooling fan of the inverter.
Set the timer value and control the On/Off state of the multi-
function output and relay.
Used to control the On/Off operation of the load’s electronic
braking system.
Multi-function output
On/Off control
Set standard values and turn On/Off the output relays or multi-
function output terminals according to the analog input value.
Regeneration
prevention for press
operation.
Used during a press operation to avoid motor regeneration, by
increasing the motor operation speed.
* Draw operation is an openloop tension control. This feature allows a constant tension to
be applied to the material that is drawn by a motor-driven device, by fine-tuning the motor
speed using operation frequencies that are proportional to a ratio of the main frequency
reference.
To Next Page
Loading...
Need help?
General
