LSIS LSLV-S100 - Page 191

Learning Advanced Features
177
Group
Co
de
Name
LCD Display
Parameter
Setting
Setting Range
Unit
selection
Mod
Level
42
PID controller unit
selection
PID Unit Sel
0
%
0-12
-
43
PID unit gain
PID Unit Gain
100.0
0-300
%
44
PID unit scale
PID Unit Scale
2
x 1
0-4
-
45
PID 2
nd
proportional
gain
PID P2-Gain
100.00
0-1000
%
In
65-
71
Px terminal
configuration
Px Define (Px:
P1-P7)
22
I-Term
Clear
-
-
23
PID
Openloop
24
P Gain2
Note
When the PID switch operation (switching from PID operation to general operation) enters the
multi-function input, [%] values are converted to [Hz] values. The normal PID output, PID OUT, is
unipolar, and is limited by AP.29 (PID Limit Hi) and AP.30 (PID Limit Lo). A calculation of 100.0%
is based on the dr.20 (Max Freq) parameter setting.
PID Basic Operation Setting Details
Code
Description
AP.01 App Mode
Set the code to 2 (Proc PID) to select functions for the process PID.
AP.16 PID Output
Displays the existing output value of the PID controller. The unit, gain, and
scale that were set at AP. 42-44 are applied on the display.
AP.17 PID Ref Value
Displays the existing reference value set for the PID controller. The unit,
gain, and scale that were set at AP. 42-44 are applied on the display.
AP.18 PID Fdb
Value
Displays the input value of the PID controller that is included in the latest
feedback. The unit, gain, and scale that were set at AP. 42-44 are applied
on the display.
AP.19 PID Ref Set
When AP.20 (PID control reference source) is set to 0 (Keypad), the
reference value can be entered. If the reference source is set to any other
value, the setting values for AP.19 are void.