LSIS LSLV-S100 - Inverter and Sequence Protection; Open-phase Protection

Learning Advanced Features
243
Code
Description
15
Stop
Outputs a signal at operation command off, and
when there is no inverter output voltage.
16
Steady
Outputs a signal in steady operation.
17
Inverter line
Outputs a signal while the motor is driven by the
inverter line.
18
Comm line
Outputs a signal while the motor is driven by a
commercial power source. For details, refer to 5.19
Supply Power Transition on page 219.
19
Speed search
Outputs a signal during inverter speed search
operation.
For details, refer to 5.15 Speed Search Operation
on page 211.
22
Ready
Outputs signal when the inverter is in stand by
operation and ready to receive an external
operation command.
28
Timer Out
A timer function to operate terminal output after a
certain time by using multi-function terminal block
input. For more details, refer to 5.30 Timer Settings
on page 230.
29
Trip
Outputs a signal after a fault trip
Refer to 5.32 Multi-Function Output On/Off Control
on page 232.
31
DB
Warn %ED
Refer to 6.2.5 Dynamic Braking (DB) Resistor
Configuration on page 261.
34
On/Off Control
Outputs a signal using an analog input value as a
standard.
Refer to 5.32 Multi-Function Output On/Off Control
on page 232.
35
BR Control
Outputs a brake release signal.
Refer to 5.31 Brake Control on page 231.
40
KEB
Operating
This outputs when the energy buffering operation
is started because of low voltage of the inverter's
DC power section due to a power failure on the
input power. (This outputs in the energy buffering
state before the input power restoration
regardless of KEB-1 and KEB-2 mode settings.)