LSIS LSLV-S100 - Page 468

454
Index
setting virtual multi-function input.......................... 278
single phase 200V (0.4~2.2 kW) .......................... 397
Slave ....................................................................... 274
slave inverter .......................................................... 148
slave unit ................................................................. 147
Slip ........................................................................... 174
slip compensation operation ................................. 174
speed command loss ............................................ 259
speed search operation ......................................... 211
Flying Start-1 ..................................................... 212
Flying Start-2 ..................................................... 212
options ................................................................ 213
P/Igain ................................................................ 214
speed unit selection (Hz or Rpm) ......................... 115
Square reduction
Square reduction load ...................................... 133
V/F pattern Operation ....................................... 133
stall
bit on/off .............................................................. 254
stall prevention .................................................. 253
Stall .......................................................................... 253
start at power-on .................................................... 123
start mode ............................................................... 138
acceleration start ............................................... 138
start after DC braking........................................ 138
Station ..................................................................... 149
Station ID ................................................................ 286
stop mode ............................................................... 139
DC braking after stop ........................................ 139
deceleration stop ............................................... 139
free run stop ...................................................... 141
power braking .................................................... 141
storage .................................................................... 395
Storing Temperature .................................................. 8
surge killer ................................................................. 37
SW1 .................... Refer to PNP/NPN mode selection
switch(SW1), Refer to PNP/NPN mode selection
switch(SW1)
SW2 ..... Refer to analog input selection switch(SW2)
SW3 Refer to analog output selection switch(SW3)
switch ........................................................................ 39
analog input selection switch(SW2) .................. 39
analog output selection switch(SW3)................ 39
PNP/NPN mode selection switch(SW1) ........... 39
Ｔ
target frequency
Cmd Frequency ................................................ 303
technical specification ........................................... 397
terminal ................................................................... 146
A terminal................................................... 146, 245
B terminal .................................................. 146, 245
terminal for frequency reference setting . Refer to VR
terminal
test run .......................................................................55
TI terminal ..........................................................42, 111
time scale
0.01sec .............................................................. 126
0.1sec ................................................................ 126
1sec ................................................................... 126
time scale setting ................................................... 125
Timer ....................................................................... 230
protection features group .. PRT (protection features)
group
TO terminal ....................................................... 43, 237
torque .........................................................................37
torque control .................................................... 207
torque reference setting option ....................... 208
torque boost ........................................................... 135
auto torque boost ...................................... 136, 137
manual torque boost ........................................ 135
overexcitation .................................................... 136
trip............................................................................ 380
fault/waring list .................................................. 271
trip condition monitor ...........................................91
trip mode...............................................................66
trip status reset.................................................. 268
Trip
troubleshooting ................................................. 384
trip(Trip)
Erase trip history ............................................... 229
troubleshooting ...................................................... 380
other faults ......................................................... 386
troubleshooting fault trips ...................................... 384
Ｕ
U&M mode ............................................................. 228
U/V/W terminal ............................................. 34, 36, 37
U/V/W terminals ............................................... 35, 386
UF ........................................................................... 355
under load
under load trip ................................................... 263
under load warning ........................................... 263