Initializing All Parameters ........................................................... 84
Frequency Setting (Keypad) and Operation
(via Terminal Input) .................................................................... 86
Frequency Setting (Potentiometer) and Operation
(Terminal Input) .......................................................................... 87
Frequency Setting (Potentiometer) and Operation (Keypad) .. 88
3.4 Monitoring the Operation ........................................................................ 90
0.4-22kW Models ........................................................................ 90
30-75kW Models ......................................................................... 93
4 Learning Basic Features ................................................................................. 99
4.1 Setting Frequency Reference ............................................................... 102
Keypad as the Source (KeyPad-1 setting) .............................. 102
Keypad as the Source (KeyPad-2 setting) .............................. 103
V1 Terminal as the Source ....................................................... 103
Setting a Frequency Reference with Input Voltage
(Terminal I2) ............................................................................. 110
Setting a Frequency with TI Pulse Input ................................. 111
Setting a Frequency Reference via RS-485
Communication ........................................................................ 113
4.2 Frequency Hold by Analog Input .......................................................... 114
4.3 Changing the Displayed Units (Hz↔Rpm) .......................................... 115
4.4 Setting Multi-step Frequency ................................................................ 115
4.5 Command Source Configuration .......................................................... 117
The Keypad as a Command Input Device .............................. 117
Terminal Block as a Command Input Device
(Fwd/Rev Run Commands) .................................................... 118
Terminal Block as a Command Input Device
(Run and Rotation Direction Commands) .............................. 119
RS-485 Communication as a Command Input Device .......... 120
4.6 Local/Remote Mode Switching ............................................................. 120
4.7 Forward or Reverse Run Prevention ................................................... 122
4.8 Power-on Run ........................................................................................ 123
4.9 Reset and Restart ................................................................................. 124
4.10 Setting Acceleration and Deceleration Times ...................................... 125
To Next Page
Loading...
