Learning to Perform Basic Operations
For some settings, pressing the [▲] or [▼] key will not increase or decrease the code number by
1. Code numbers may be skipped and not be displayed. This is because certain code numbers
have been intentionally left blank (or reserved) for new functions to be added in the future. Also
some features may have been hidden (disabled) because a certain code has been set to disable
the functions for relevant codes.
As an example, if Ad.24 (Frequency Limit) is set to 0 (No), the next codes, Ad.25 (Freq Limit Lo)
and Ad.26 (Freq Limit Hi), will not be displayed. If you set code Ad.24 to 1 (Yes) and enable the
frequency limit feature, codes Ad.25 and 26 will appear to allow the maximum and minimum
frequency limitations to be set up.
3.2.2.2 30-75kW Models (Switching Groups)
Press the [MODE] key to display a specific mode. Modes displayed change in the following
order:
To Next Page
Loading...
