5.6.3 Skew Check Menu 275
5.6 Adjustment Menu VJ628XE-M-00
5.6.3 Skew Check Menu
Feed the paper to check the skew size using Sensor.
When you select this item from the Adjustment Menu, the printer feeds the loaded media
(specified amount) and checks difference of the media edge positions before and after the
media feed detected by Sensor.
Before performing skew check, ensure that the media is set correctly.
The printer determines the media setting reference position during the first detection
of media left edge. Therefore, the media that is not set correctly may cause errors as
below:
• Media error occurs during skew check and printer operation stops.
• During media initial operation after power is turned on, "Undefined Paper" is
frequently displayed.
• When the skew result is beyond ±9.99mm, +9.99mm or -9.99mm is displayed.
[Enter]
[Enter]
[Cancel]
㹋㹣㹢㹧㹟㹑㹪㹟㹬㹲㸸ࠉࠉࠉࠉࠉ㸯㸬㸮㹫
㹒㹣㹱㹲ࠉ㸱㸸㹁㹦㹣㹡㹩㹑㹩㹣㹵
㹁㹦㹣㹡㹩ࠉ㸱㸸㹒㹣㹱㹲
㹑㹣㹲ࠉ㹋㹣㹢㹧㹟
㹃㹶㹡㸬ࠉ㹑㹩㹣㹵
㹑㹩㹣㹵㹐㹣㹱㹳㹪㹲㸸ࠉࠉ㸩㸮㸬㸮㸯㹫㹫
Set by [+]/[-] key
[Enter]
[Enter]
after setting a media
Paper edge detection finishes normally
0.1 to 10.0㹫(0.1㹫
increments)
If a media is not set
To Next Page
Loading...
Need help?
General