4.3.8 Receiving Backup Parameters 202
4.3 Working with MUTOH Service Assistance Software VJ628XE-M-00
4.3.8 Receiving Backup Parameters
This section describes the procedure to receive backup parameter from the printer by using
Technician mode.
Saving backup parameter and main board inheritance information acquisition can be
processed both from printer mode and board manager mode.
Before this procedure, make sure to prepare the following:
• Set up the printer, computer and MSA.
"4.3.3Required Environment
• Change to Technician mode on MSA.
"(12)Switching to Technician Mode
1 Click [Parameter Download] on main
window.
2 Click [OK] on [Parameter Download]
window to start receiving backup
parameters.
After clicking [OK], if any communication errors occur such as wrong IP address or
unplugged LAN cable, an error message appears. If any setting errors occur such
as inappropriate model name selection, serial number registration is not finished or
incorrect one is registered, an warning message appears.
In both cases, communication with printer shall be interrupted.
Click [OK] to return to main window.
3 While receiving Parameters,
[Progress] window appears.
4 On [Parameter download ]
window, click [OK] to close the
window.
5 Enter any file name and click
[Save] on [Save the download
parameter save] window. (File
shall be saved in “.prm” extension
form automatically.)
*File name can be anything.
** Click [Cancel] to return to the
previous window without saving.
To Next Page