for checking
Horizontal slant
for checking
Vertical slant
Check Head Slant 1 (Horizontal)
According to the width of media,
following adjustment pattern is printed on
three places or less.
Paper feed direction
Origin side
Print Adjustment pattern
20mm
Nozzle
[Enter]
[Enter]
㹁㹦㹣㹡㹩ࠉ㸱㸸㸿㹢㹨㹳㹱㹲㹫㹣㹬㹲
[Enter]
㸿㹢㹨㹳㹱㹲㹫㹣㹬㹲ࠉ㹎㹰㹧㹬㹲
after printing
㸿㹢㹨㸬ࠉ㸲㸸㹆㹣㹟㹢㹑㹪㹟㹬㹲
㹆㹣㹟㹢㹑㹪㹟㹬㹲㸸㹑㹪㹟㹬㹲㸯
[Enter]
㸿㹢㹨㹳㹱㹲ࠉ㹆㹣㹟㹢ࠉ㹅㹟㹮
Check the Slant (Horizontal) at Connecting points (Refer to the following and an enlargement.)
BࠉࠉHࠉࠉBࠉࠉBࠉࠉFࠉࠉBࠉࠉBࠉࠉDࠉࠉBࠉࠉAࠉࠉGࠉࠉAࠉࠉAࠉࠉEࠉࠉAࠉࠉAࠉࠉCࠉࠉA
1passࠉUni-D/Bi-D
PF:360dpiࠉCR:360dpi
Check the slant (Horizontal):
ࠉFor CW printing, the nozzles combination are, from the media
origin side, A/C, A/E, B/D, B/F, and B/H.
ࠉ320cps, VSD1, Small dot
㹒㹇㹎
(1) Check th eposition of Black and each color.
ࠉIn ۑ, No need for adjustments.
In , it adjust, respectively and be set to
ۑ. Refer to the
4.7.1ࠕHead Alignment (Horizontal Slant)
(2) Repeat printing and adjustment
until a result becomes ۑ.
Connecting point enlargement㸸Ex. Nozzle A,C
To Next Page