5.11.4 Pump endurance Menu 334
5.11 Endurance Running Menu VJ628XE-M-00
5.11.4 Pump endurance Menu
This menu is used to perform endurance running for Pump.
You can drive Pump motor according to your desired settings.
The available settings are shown below.
• If the number of endurance running cycles is set to -1, Pump motor continuously
repeats endurance running until [Cancel] input is given from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-
digit number). If the number of cycles exceeds the maximum value, the counter
displays 99999999.
The movement sequences of the pump endurance are as follows.
1 Pump endurance running starts.
2 Rotates at the specified suction speed. This rotation is counted as one cycle.
Super high :10.0 s
High : 10.0 s
Normal: : 10.0 s
Low: : 10.0 s
3 The number of endurance is counted +1.Back to Step 2 above.
(Repeat the specified number of times.)
4 Pump endurance running ends.
Set item Contents Set value
Running speed Set the running speed of
Pump.
Super high / High / Normal /
Low)
Life Count Set the number of
endurance running cycles.
-1, 1 to 10000
>!@
>@
[Enter]
[Enter]
㹊㹧㹤㹣㹁㹭㹳㹬㹲㸸ࠉࠉࠉࠉࠉࠉࠉࠉ㸳㸮
[Enter] /
[Cancel]
㹁㹦㹣㹡㹩ࠉ㸶㸸㹃㹬㹢㹳㹰㹟㹬㹡㹣
㹁㹭㹳㹬㹲㸸ࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉ㸯㸮ࠉ
㹃㹬㹢㸸ࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉ㸳㸮
[Enter]
㹎㹳㹫㹮㸸㹑㹳㹮㹣㹰㹆㹧㹥㹦
㹊㹧㹤㹣ࠉ㸲㸸㹎㹳㹫㹮
㹎㹳㹫㹮㸸㹌㹭㹰㹫㹟㹪
㹎㹳㹫㹮㸸㹊㹭㹵
㹎㹳㹫㹮㸸㹆㹧㹥㹦
[Enter]
Endurance Count
Performing endurance
Completing endurance or [Cancel]
Change the value (unit to count)
by pressing[+] /[-] key.
To Next Page
Loading...
