Troubleshooting
7-7
Part 1123087_02
3/2014 Nordson Corporation
To transfer the event log and diagnostic files to your computer
1. Switch off the melter and disconnect and lock out input power to the
melter.
2. See Figure 7‐6. Open the touchscreen assembly as follows:
a.. Loosen, but do not remove, the screws on the underside of the
touchscreen assembly.
b.. Lift up the entire panel and tilt the top of the panel away from the
melter.
Figure 7‐6 Location of the touchscreen assembly screws
To Next Page
Loading...
