Troubleshooting
7-8
Part 1123087_02
3/2014 Nordson Corporation
To transfer the event log and diagnostic files to your computer
(contd)
CAUTION! There are two SD cards. Take care to access only the customer
SD card shown in this procedure. If the internal SD card is disturbed, unit
operation can be disrupted.
3. See Figure 7‐7. Remove the customer SD card. The customer SD card is
identified by a tag on the back of the touchscreen assembly.
Figure 7‐7 Location of the customer SD card
4. Using a PC or laptop with an SD card reader/writer, copy the following
files from the customer SD card to your computer:
eventlog.csv
eventlog02.csv (if present)
disgnostic.csv.
5. Reinstall the customer SD card and close the touchscreen assembly as
follows:
a.. Lift the assembly up, push it back towards the chassis, and then let it
drop onto the pins.
b.. Tighten the screws loosened previously.
6. Restore power to the system and switch the melter on.
7. Refer to About the Eventlog.csv File and to About the Diagnostic.nor File
for information on how to use these files.
To Next Page
Loading...
