Pin removal tool
Contents of the RTD service kit:
RTD harness
Cable ties
Repair
8-7
Part 1123087_02
3/2014 Nordson Corporation
To remove an RTD
See Figure 8‐3.
1. Remove the two screws that secure the RTD retaining clip (1, 3) to the
hydraulics assembly and then remove the RTD from the slot.
2. Disconnect the bulkhead harness connector (5) from the top left side of
the hydraulics enclosure.
1
2
3
4
5 (BHRX1)
Figure 8‐3 Replacing an RTD or a thermostat
1. Grid RTD retaining clip
2. Grid thermostat (covered by boot)
3. Manifold RTD retaining clip
4. Manifold thermostat (covered
by boot)
5. Bulkhead harness connection
To Next Page
Loading...
