Contents of the thermostat service
kit:
Thermostat
Thermal compound
Socket‐head cap screws
Insulator boot
Cable ties
Repair
8-9
Part 1123087_02
3/2014 Nordson Corporation
To replace a thermostat
See Figure 8‐5.
1. Cut the cable ties that secure the thermostat boot (2, 4) and remove the
boot.
2. Disconnect the spade connectors from the thermostat and remove the
thermostat.
3. Apply thermal compound to the new thermostat and install it using the
new screws from the service kit.
4. Reconnect the spade connectors.
5. Install a new boot on the thermostat and secure the boot with the cable
ties.
6. Close the hydraulics assembly insulation, reinstall the hydraulics cover,
and restore the system to normal operation.
1
2
3
4
5 (BHRX1)
Figure 8‐5 Replacing an RTD or a thermostat
1. Grid RTD retaining clip
2. Grid thermostat (covered by boot)
3. Manifold RTD retaining clip
4. Manifold thermostat (covered
by boot)
5. Bulkhead harness connection
To Next Page
Loading...
