Repair
8-46
Part 1123087_02
3/2014 Nordson Corporation
To remove the hydraulics assembly
1. See Figure 8‐31. Disconnect or remove the following components:
Bulkhead harness connector (1)
Hydraulic tilt switch harness on pump top bracket (2)
Pneumatic control assembly power cable (3)
Cyclone upper body (4) (refer to To remove the cyclone assembly
earlier in this section if needed)
Hydraulics assembly ground strap (5)
Level sensor cable and ground wire (6)
Hoses (7)
Air lines to the T‐fitting on the pressure discharge valve (8)
5
7
8
1
6
4
2
3
Figure 8‐31 Preparing to remove the hydraulics assembly
1. Bulkhead harness connection
2. Hydraulic tilt switch harness
3. Pneumatic assembly power cable
4. Cyclone upper body
5. Hydraulics assembly ground strap
6. Level sensor cable connection
7. Hose connection location
8. Pressure discharge valve
T‐fitting
To Next Page
Loading...
