13. Select the DEnlarged/Reduced Printing check box.
14. Click GScaling and enter 120.
Note
･ You can specify enlargement that exceeds the paper size, but in this case,
the portion off the edge of the paper will not be printed.
･ If the original size after enlargement or reduction is smaller than the paper
size, the original is printed in the upper-left corner. In this case, you can
center originals by selecting the
JPrint Centered check box.
15. Confirm the print settings, and then click MPrint to start printing.
Note
･ For tips on confirming print settings, see "Confirming Print Settings (
5.1.3)"
To Next Page
Loading...
