11. 5. 9. Troubleshooting > Problems with the printing quality >
Image edges are blurred or white banding occurs
Cause Corrective Action
The Platen suction
is too strong.
In the Control Panel menu, set VacuumStrngth to
Weakest.
(See "Adjusting the Vacuum Strength
(VacuumStrngth) (
7.2.7).")
The Printhead is
set too high in the
Control Panel
menu.
In the Control Panel menu, set Head Height to
Lowest.
(See "Troubleshooting Paper Abrasion and Blurry
Images (Head Height) (
7.1.5).")
The type of paper
specified in the
printer driver does
not match the type
loaded in the
printer.
Load paper of the same type as you have specified
in the printer driver.
(See "Loading Rolls in the Printer (6.2.2).")
(See "Loading Sheets in the Printer (6.3.1).")
Make sure the same type of paper is specified in the
printer driver as you have loaded in the printer.
1. Press the Stop button and stop printing.
2. Change the type of paper in the printer driver
and try printing again.
To Next Page
Loading...
