11. 4. 2. Troubleshooting > The printer stops during a print job >
The printer ejects blank, unprinted paper
Status Corrective Action
The leading edge of the
roll paper was cut to
straighten it.
The leading edge of rolls may be cut to
straighten it if you have selected Trim Edge
First >On or Automatic in the Control Panel
menu.
(See "Cutting the Leading Edge of Roll Paper
Automatically (
6.2.14).")
The Printhead nozzles
are clogged.
Print a test pattern to check the nozzles and
make sure the Printhead is in good condition
for printing.
(See "Checking for Nozzle Clogging (10.2.2).")
A print job was received
from an incompatible
printer driver.
Use the correct printer driver for the printer
and try printing again.
The printer has received
print data that includes
HP RTL commands when
Auto Rotate is On in
the Control Panel menu.
In the Control Panel, set Auto Rotate to Off
and print again.
(See "Menu Settings (8.2.8).")
The printer is damaged. Contact your Océ dealer for assistance.
To Next Page
Loading...
