12. 1. 2. Error Message > Error Messages >
Cannot adjust paper feed.
Cause Corrective Action
The Printhead nozzles
are clogged.
Execute Adj. Quality again, as follows.
1. Press the OK button to clear the error.
2. Print a test pattern to check the nozzles.
(See "Checking for Nozzle
Clogging (
10.2.2).")
3. Clean the Printhead if the nozzles are
clogged.
(See "Cleaning the Printhead (
10.2.3).")
4. Execute Adj. Quality again.
(See "Automatic Banding Adjustment (Adj.
Quality) (
7.2.3).")
Highly transparent film
is loaded that cannot be
used for automatic feed
amount adjustment.
Press the OK button to clear the error, and
then adjust the feed amount manually.
(See "Manual Banding Adjustment (Adj.
Quality) (
7.2.4).")
To Next Page
Loading...
Need help?
General