6. 2. 1. Handling Paper > Handling rolls >
Attaching the Roll Holder to Rolls
When printing on rolls, attach the Roll Holder to the roll.
Rolls have a two- or three-inch paper core. Use the correct attachment for the paper core. The printer comes
equipped with the 2-Inch Paper Core Attachment installed.
Using Rolls with a 2-Inch Paper
Core
Using Rolls with a 3-Inch Paper Core
Holder Stopper
(Left Side)
Roll Holder
(Right Side)
Holder Stopper (Left Side) Roll Holder (Right Side)
2-Inch Paper Core
Attachment
No
Attachment
Needed
3-Inch Paper Core
Attachment L
3-Inch Paper Core
Attachment R
Caution
ï½¥ Set the roll on a table or other flat surface so that it does not roll or fall. Rolls are heavy,
and dropping a roll may cause injury.
Important
ï½¥ When handling the roll, be careful not to soil the printing surface. This may affect the
printing quality. We recommend wearing clean cloth gloves when handling rolls to protect
the printing surface.
ï½¥ Use scissors or a cutting tool to cut the edge of the roll paper if it is uneven, dirty, or has
tape residue. Otherwise, it may cause feeding problems and affect the printing quality. Be
careful not to cut through any barcodes printed on the roll.
ï½¥ Align the edges of the paper on both ends of the roll. Misalignment may cause feeding
problems.
Note
To Next Page
Loading...
Need help?
General