9. 1. 6. Network Setting > Network Setting >
Configuring TCP/IPv6 Network Settings
When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control
Panel.
Follow the steps below to configure the TCP/IPv6 network settings.
1. On the Tab Selection screen of the Control Panel, press or to select the Settings/
Adj. tab (
).
Note
ï½¥ If the Tab Selection screen is not displayed, press the Menu
button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press or to select Interface Setup, and then press the OK button.
4. Press or to select TCP/IP, and then press the OK button.
5. Press or to select IPv6, and then press the OK button.
6. Press or to select IPv6 Support, and then press the OK button.
7. Press or to select On, and then press the OK button.
Important
ï½¥ Once you set IPv6 Support to On, the IPv6 StlessAddrs setting takes
effect.
ï½¥ You can also configure IPv6 StlessAddrs and DHCPv6 from the printer
Control Panel.
To Next Page
Loading...
Need help?
General