6. 2. 6. Handling Paper > Handling rolls >
Removing the Roll from the Printer
Remove rolls from the printer as follows.
Note
ï½¥ If you need to cut the roll, see "Specifying the Cutting Method for Rolls (
6.2.13)."
1. On the Tab Selection screen of the Control Panel, press or to select the Paper tab ( ).
Note
ï½¥ If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Paper Menu is displayed.
3. Press or to select Eject Paper, and then press the OK button.
4. Press or to select "Yes", and then press the OK button.
The roll is now rewound and ejected.
Caution
ï½¥ If you have selected ManageRemainRoll >On in the Control Panel menu, a
barcode is printed on the leading edge of the roll.
Do not remove the roll before the barcode is printed. You will be unable to keep
track of the amount of roll paper left. (See "Keeping Track of the Amount of Roll
Paper Left (
6.2.11).")
5. Positioning your hands as shown, open the Roll Cover.
To Next Page
Loading...
Need help?
General