･ Prepare a new Ink Tank when ink levels are low.
･ Your hands may become dirty during Printhead replacement. Use the gloves
provided with the new Printhead for replacement.
1. If the roll is not ejected because of the cutting method selected, cut it manually and
remove it. (See "Cutting Roll Paper After Printing (
3.12.9).")
2. Clean inside the Top Cover. (See "Cleaning Inside the Top Cover (10.4.2).")
3. On the Tab Selection screen of the Control Panel, press or to select the Settings/
Adj. tab (
).
Note
･ If the Tab Selection screen is not displayed, press the Menu
button.
4. Press the OK button.
The Set./Adj. Menu is displayed.
5. Press or to select Maintenance, and then press the OK button.
6. Press or to select Replace P.head, and then press the OK button.
Ink is now filled.
After about two minutes, a message is shown on the Display Screen instructing you to open
the Top Cover.
Replace the Printhead
1.
Open the Top Cover.
To Next Page
Loading...
