6. 2. 11. Handling Paper > Handling rolls >
Keeping Track of the Amount of Roll Paper Left
Setting ManageRemainRoll to On in the Paper Menu of the Control Panel will print a barcode with text on
the roll when the roll is removed that identifies the type of paper and amount left. When ManageRemainRoll
is On and you load rolls with printed barcodes, the type of paper and amount left are automatically detected
after rolls are loaded. The barcode will be cut off after it has been read.
Important
･ Because the ManageRemainRoll function is not compatible with clear film, an error
message may be displayed ( "The roll is empty." ) after you load clear film. For this
reason, set ManageRemainRoll to Off before loading clear film.
･ If the barcode on the roll is not detected, enter the type and length of paper on the
Control Panel.
Follow these steps to set ManageRemainRoll to On as follows.
1.
On the Tab Selection screen of the Control Panel, press or to select the Paper tab ( ).
Note
･ If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Paper Menu is displayed.
3. Press or to select ManageRemainRoll, and then press the OK button.
4. Press or to select On, and then press the OK button.
To Next Page
Loading...
