6. 2. 4. Handling Paper > Handling rolls >
Specifying the Paper Length
When changing the length of paper after the paper has been advanced, specify the length as follows.
Note
･ Specify the paper length when you have set ManageRemainRoll to On. (See "Keeping
Track of the Amount of Roll Paper Left (
6.2.11).")
1. On the Tab Selection screen of the Control Panel, press or to select the Paper tab ( ).
Note
･ If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Paper Menu is displayed.
3. Press or to select Chg. Paper Size, and then press the OK button.
4. Press or to select Roll Length, and then press the OK button.
5. Press or to select the length of paper loaded in the printer, and then press the OK button.
Specify the roll length as follows.
1.
Press the or button to move to the next field for input.
2. Press the or button to enter the value.
3. Repeat steps 1 and 2 to finish entering the value, and then press the OK button.
To Next Page
Loading...
