7. 2. 1. Adjustments for Better Print Quality > Adjusting the feed amount >
Adjusting the Feed Amount
If printed documents are affected by the following problems, try adjusting the feed amount.
● Banding in different colors
● Line length is not accurate in the direction paper is fed
To adjust the feed amount, do the following, in this order.
1.
Depending on the issue, adjust Adj. Priority to suit the particular type of paper.
(See "Selecting a Feed Amount Adjustment Method (Feed Priority) (7.2.2).")
2. Execute Adj. Quality or Adjust Length, depending on the selection in Adj. Priority.
(See "Automatic Banding Adjustment (Adj. Quality) (7.2.3).")
(See "Manual Banding Adjustment (Adj. Quality) (7.2.4).")
(See "Adjusting Line Length (Adjust Length) (7.2.6).")
3. After executing Adj. Quality, execute Adj. Fine Feed for further adjustment as needed.
(See "Fine-Tuning the Paper Feed Amount (Adj. Fine Feed) (7.2.5).")
To Next Page
Loading...
