10. 5. 1. Maintenance > Other Maintenance >
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow these steps before transferring the printer to
a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Important
･ Be sure to contact your Océ dealer before transferring the printer to a new
location. Ink may leak and damage the printer if you do not prepare the
printer correctly and it is tipped or stood on end in transit.
Note
･ It is not possible to prepare the printer for transfer if the Display Screen
requests you to replace the Maintenance Cartridge or check the remaining
capacity. Replace the Maintenance Cartridge before transfer preparations. In
this case, you will need one new Maintenance Cartridge. (See "Replacing the
Maintenance Cartridge (
10.3.2).")
･ Depending on the state of the printer, part replacement may be necessary
when preparing to transfer the printer (that is, when you execute the printer
menu item to prepare for transfer).
Remove paper
1.
Remove the paper.
● Rolls (See "Removing the Roll from the Printer (6.2.6).")
● Sheets (See "Removing Sheets (6.3.4).")
Access the Move Printer menu
1.
On the Tab Selection screen of the Control Panel, press or to select the Settings/
Adj. tab (
).
To Next Page
Loading...
Need help?
General