12. 1. 50. Error Message > Error Messages >
The roll is empty.
Cause Corrective Action
The roll is empty.
Follow these steps to replace the used roll with a
new roll of the same type and size.
1. Press the Release Lever back and remove
the roll.
(See "Removing the Roll from the
Printer (
6.2.6).")
(See "Removing the Roll Holder from
Rolls (
6.2.7).")
2. Load the new roll.
(See "Attaching the Roll Holder to
Rolls (
6.2.1).")
(See "Loading Rolls in the Printer (
6.2.2).")
3. If no barcode was printed on the roll, specify
the type of paper.
(See "Changing the Type of Paper (
6.2.3).")
4. When you have selected
ManageRemainRoll >On in the control panel
menu and a barcode is not printed on the roll,
also specify the paper length.
(See "Specifying the Paper Length (
6.2.4).")
5. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page on
which the error occurred.
There is remaining
roll paper, but
because it could not
be advanced, it could
not be detected.
Choose a higher level of Print Quality in the
Advanced Settings of the printer driver.
(See "Giving Priority to Particular Graphic
Elements and Colors for Printing (
3.1.4).")
To Next Page
Loading...
